 |
|||||
|
|
|
|
|||
 |
|
EmuTec offers more then 60 different adapters to support a variety of footprints and target connections between PROMJet and target boards. The ones presented below show some of the available adapters. Please check with EmuTec if you need to support any other configuration. Please be patient while the page is loading since it has quite a few pictures. |
|
TSOP adapter:
This adapter is used to connect PROMJet to a 16 or 8 bit TSOP FLASH memory. It interfaces directly to the 50-pin connector or uses a rewiring adapter to support various pin-outs. |
 |
|
SPI FLASH adapter:
PROMJet uses this adapter to emulate Serial SPI Flash Memory. It plug in the 50-pin connector and interfaces to an 8-pin SOIC footprint. The adapter does not have any active components. |
 |
|
DIP and PLCC extension cable (8bit):
PROMJet plugs from the top using the DIP connector. DIP or PLCC extension cable plugs from the bottom side via the IDC connector. |
 |
|
DIP and PLCC extension cable (2 x 8bit):
PROMJet plugs from the top via the 50 pin connector. DIP or PLCC extension cables plug from the bottom using the IDC connectors. |
 |
|
PLCC extension cable (8bit):
Flat ribbon cable connected to a PLCC plug. The other side of the cable plugs using one of the adapters above. |
 |
|
DIP Male to Male adapter (8bit):
This male to Male adapter is used to connect PROMJet to a DIP socket or any adapter using a DIP connection. |
 |
|
PLCC adapter (8bit):
This 32-pin PLCC adapter is used to emulate a 32-pin PLCC FLASH or EPROM. Plugs into PROMJet using the DIP adapter. |
 |
|
DIP 40/42-pin adapter (16bit):
This 40/42 pin adapter is used to emulate a 40 or 42 pin 16-bit EPROM. PROMJet plugs from the top via the 50-pin connector. |
 |
|
PLCC adapter (8Bit, 16Bit and 4Bit (LPC/FWH):
This PLCC adapter connects to PROMJet via the 50-pin connector. It is available for both 16-bit (44 pin) and 8bit (32 pin). It can use the Flex extension cable for more flexibility. |
 |
|
Flex expansion cable:
This Flex cable is used to connect between a PROMJet and any adapter or target board using the 50-pin connector. It is very useful for high-speed applications. |
 |
|
Rewiring adapter:
This kind of adapter is used to reroute PROMJet signals to match other pin-outs. EmuTec offers quote a number of such adapters to interface to various targets. This adapter plugs into PROMJet via the 50-pin header. From the bottom side, it interfaces to a 60-pin AMP female connector. |
 |
|
Split/Cascade adapter:
This adapter is used to cascade two PROMJets into a single unit with double the capacity. It can also take one PROMJet and split it to high and low bytes. |
 |
|
PSOP FLASH adapter:
This adapter is used to support PSOP FLASH memory. It plugs into PROMJet via a rewire adapter. This head will be soldered into the target board and are replacable. A Flex extension cable can be used for more flexibility. |
 |
|
|